This is the Keck Clip for the 14mm ground joints. The clip holds together either the 14 female and the...[more]
This is the Keck Clip for the 19mm ground joints. The clip holds together either the 19 female and the...[more]
This is the Keck Clip for the 24mm ground joints. These Keck Clips are only available in white at this...[more]
This is the Keck Clip for the 24mm ground joints. Green [more]
This is the Keck Clip for the 45mm ground joints. These Keck Clips are only available in white and red....[more]
The 11mm Female ground joint holder from WhatisArt holds the 11 Female by fitting a hollow graphite taper around the...[more]
The 11mm Male ground joint holder from WhatisArt holds the 11 Male by fitting a hollow graphite taper around the...[more]
This Female Holding tool from Blast Shield holds a 19mm male ground joint by fitting into the ground end with...[more]
The water attachment from Herbert Arnold fits a drill press between the press and the diamond bit, allowing water to...[more]
The 19mm Male tool from Herbert Arnold is a hollow aluminum taper, the interior is covered in graphite paper that...[more]
[more]
This Female Holding tool from WhatisArt holds a 14mm Female ground joint by fitting into the ground end with a...[more]
This Female Holding tool from Blast Shield holds a 14mm Female ground joint by fitting into the ground end with...[more]
The 14mm Male ground joint holder from WhatisArt holds the 14 male by fitting a hollow graphite taper around the...[more]
This Female Holding tool from Blast Shield holds a 14mm male ground joint by fitting into the ground end with...[more]
This Female Holding tool from WhatisArt holds a 19mm Female ground joint by fitting into the ground end with a...[more]
This Female Holding tool from Blast Shield holds a 19mm Female ground joint by fitting into the ground end with...[more]
The 19mm Male ground joint holder from WhatisArt holds the 19 male by fitting a hollow graphite taper around the...[more]
The 29mm Female ground joint holder from WhatisArt holds the 29 Female by fitting a hollow graphite taper around the...[more]
The 29mm Male ground joint holder from WhatisArt holds the 29 Male by fitting a hollow graphite taper around the...[more]
